iFlight BNF FPV Quadcopter Factory CLI Dumps

iFlight BNF FPV Quadcopter Factory CLI Dumps

Iflight drones (such as Nazgul series) come pre-configured, requiring users to only set flight modes and bind the receiver as needed. However, there may be times when you need to update the firmware and apply new factory defaults. This guide will walk you through the process of downloading and applying the correct CLI dumps for your Iflight drone.

Important Safety Notice

Warning: Loading the wrong CLI dump can cause your drone to crash, which is not covered under warranty. Always ensure you're using the correct dump for your specific drone model and firmware version.

Steps to Download and Apply Factory Defaults

  1. Identify Your Drone's Specifications
    • Check your product box or specifications to identify the correct flight controller target.
    • Note the version of Betaflight currently installed on your drone.
  2. Locate the Correct CLI Dump
  3. Download the CLI Dump
    • Download the correct CLI dump file to your computer.
  4. Apply the CLI Dump
    • Connect your drone to your computer.
    • Open the Betaflight Configurator.
    • Go to the CLI tab.
    • Copy and paste the contents of the downloaded CLI dump into the CLI window.
    • Press Enter to execute the commands.
  5. Verify the Update
    • Check that all settings have been applied correctly.
    • Test your drone in a safe environment before flying.

Finding the Right CLI Dump

Iflight provides a comprehensive resource for locating the correct firmware, wiring diagrams, and factory dumps for your specific drone. Visit the following link and select the corresponding parameters for your drone: https://iflightrc.freshdesk.com/support/solutions/articles/48001148115-firmware-wiring-factory-dumps

Additional Tips

  • Always backup your current configuration before applying a new CLI dump.
  • If you're unsure about any step in this process, consult with an experienced drone pilot or contact Iflight support.
  • Regularly check for firmware updates and new CLI dumps to ensure optimal performance of your drone.

How to load CLI Defaults


    • Related Articles

    • Betaflight Firmware Guide for iFlight BNF Drones

      Important Disclaimer More than 50% of our support work is linked to messed up firmware, flash-bricked flight controllers or misconfigured BNF drones. So don't waste your time or money, FPV quads are more fun flying than fixing... Before proceeding ...

    • Loading CLI Defaults onto Your Betaflight Flight Controller/Drone: A Step-by-Step Guide

      Important things to note when using CLI Dumps/Diff When using CLI dumps, there are several important things to keep in mind: Always make sure the version of Betaflight firmware on your board is the same version as that on the CLI Dump file. While you ...

    • BetaFlight Resource Mapping Guide

      As manufacturers are stuffing more and more features into flight controllers, we are increasingly seeing boards that have fewer pins available for accessories. The result is lost capabilities, such as: Not enough UART input/outputs Inability to fly ...

    • How To Properly Setup And Configure A BetaFlight Quadcopter

      In our experience many problems we encounter with customers stem from incorrect configuration/setup of Betalight.  While Betaflight is an impressive flight control firmware, there are hundreds of parameters that you can tweak and play around with so ...

    • Betaflight Camera Control Setup and Troubleshooting

      Camera control via Betaflight is a fantastic way to adjust your camera settings from your R/C Controller, but it can sometimes be abit tricky to get working properly.  Since this is an open source software feature, we are only able to provide limited ...